Polaris indy / wedge chassis parts Granger Indiana

I have pictures of all of the parts that I can if needed. Prices do not include shipping. PayPal accepted, add 4% for PayPal fees. Reasonable offers considered. All parts are in good condition and were removed from a working sled that had front left suspension and hood damage from a recent accident.

440 L/C engine with carbs, recoil start, oil & water pumps, electronics (flywheel & stator plate), engine plate, throttle & choke cables, temperature sensor. Ready to bolt in and go! (120 & 125 psi compression, clean inside & out, runs great never had problems with it) $450.00

Newer 1”taller type front spindles (late 90’s Polaris sleds with Xtra 10 suspension) $50 (for both)

Polaris cover from late 90’s wedge chassis sled (overall good trailerable condition, has some patches over previous tears, has been used regularly on trips on my open trailer) $35

2 pc seat/gas tank (seat is in excellent condition, tank is 10 gal size with electric fuel gauge sending unit, tank cover has some cracking around gas cap and a small tear on one side) $50 (for all) or $40 for seat and tank cover

Secondary clutch (new spring and large bushing last winter) $25

Red Nose cone (excellent condition) $25

Drive axle with sprockets $15

Handlebars with throttle block, light switch and hand warmers $25

Oil and coolant tanks $15 (for both)

Headlight and gauge pod with tach, speedometer and electric fuel gauge $25

Right trailing arm (Nice condition) $35

Muffler and Y pipe $25 (for both)

2 Metal Skis $25 (for both)

Front shocks (newer shocks and springs, one shock is bent on the top end, good spring and retainers) $15 (for both)

Speedometer cable and righ angle drive unit that attaches to drive axle (includes axle bearing flanges) $10

2 Hood hinges (red) $5 (for both)

Snowflap with bracket (red Polaris lettering) $10

Handlebar pad (red Polaris lettering) $8

Fuel pump with gas lines $10

Airbox $5

Electric starter with engine mounting bracket, battery box, starter solenoid & key switch (should fit many different models with similar engines) $70

Front & rear bumper with (4) plastic bumper trim pieces $30 (for all)

Hydraulic brake assembly (lever assembly and caliper with good brake pads) $25

Aluminum hood brace (brace that the hood cable attaches to on inside of hood) $5

Tunnel – belly pan assembly (tunnel and frame are straight, includes all 3 radiators, have a valid registration if needed. *I will sell the radiators separately) $Make offer!

*(3) Radiators (two sides and one center) $75 (for all 3, if not sold with tunnel)

Rear suspension (XC-100) from a 1995 Indy Trail (good hyfax, no rear shock, has heavier torsion springs from a ’97 XC 700) $35

Other misc. parts can be taken off the frame/tunnel, just ask and I can see if I have it.